This guide explains the process of installing the Qradar plugin, the procedure is the same for any other type of plugin.
To do this, it is only necessary to use the Qradar installation script and create the Qradar sensor in the manager.
Use of the installation script
We will place the installation script in the root directory. The permissions will be assigned by means of the sentence:
chmod 777 configure-qradar.sh
Once the permissions have been assigned, we will use the script with the following statement:
The installation will start and we will receive a message confirming the installation of the plugin.
Once we have the system prepared we can create the corresponding sensors to receive the information, in this case from Qradar.
Through the graphical interface we can add a sensor with the desired name and the corresponding IP
Once the sensor is created it will only be necessary to select the dimensions that you want to visualize within the Qradar category
Uninstalling the plugin
If you want to revert the initial situation you can use the installation script using the following statement:
It would also be necessary to remove the sensor in the manager to avoid anomalous behavior.
Click on the icon indicated in the image and in the next pop-up click on "Delete Qradar"